Create a bug fully from one block in Blender. Finished
Decide on either one large bug or a bunch of smaller ones. A bunch
The bug that I created here was all from just one start block in blender. While I am proud of how it turned out, I was unable to fully complete the small details because it became too much for my computer to handle. Also, apparently it also has too many faces for it to even be colored in Blender, go figure. Nevertheless, I like how it turned out and hope to make more. In retrospect, it might of been easier if I started off with an easier bug, but I love praying mantises.
 |
| I based my mantis off of this photo. Courtesy of Google search. |
 |
| My mantis created in Blender, seen from the side. |
 |
| It's back side. The wings were among the hardest objects to render using only a single block. |
 |
| My mantis seen from underneath. |
 |
| A bit of the details that I tried to render on its face. I wasn't able to produce the jaws perfectly, but I think that it's pretty close. |
--VMS
No comments:
Post a Comment